# Hardwood floor installation & refinishing in Grimsby

Grimsby is a narrow strip of housing between the escarpment and the lake, with an older downtown core, a band of post-war housing, and newer subdivisions and lakeside development at either end. It is the point where the QEW run stops being suburban and starts being Niagara.

## Areas covered

Grimsby Beach, Downtown Grimsby, Casablanca, Grimsby Mountain, Winston Park.

## Housing stock and what it means for the floor

The older core carries pre-war and post-war stock where original softwood or early strip hardwood may need board replacement before it can take a uniform finish, while the newer lakeside and escarpment builds are plywood over joists and are installation work. Houses on the lake side hold summer humidity longer than those above the brow, which shows up as seasonal gapping in a floor acclimated on a schedule rather than a meter.

## The practical constraint here

The escarpment gives this town two microclimates a few hundred metres apart. Whether a house sits above or below the brow is worth knowing before a species and a board width are settled.

## Services delivered here

- **Hardwood Flooring Installation** ($11.00–$18.00 per sq ft) — https://ecowoods.ca/services/hardwood-installation
- **Hardwood Floor Refinishing** ($4.75–$7.50 per sq ft) — https://ecowoods.ca/services/floor-refinishing
- **Dust-Free Floor Sanding** — https://ecowoods.ca/services/dust-free-sanding
- **Hardwood Floor Restoration** ($4.75–$7.50 per sq ft) — https://ecowoods.ca/services/floor-restoration
- **Stair Refinishing** ($4.75–$7.50 per sq ft) — https://ecowoods.ca/services/stair-refinishing
- **Custom Inlays & Borders** — https://ecowoods.ca/services/custom-inlays


---

## Provenance

- Canonical URL: https://ecowoods.ca/service-areas/grimsby
- Publisher: Ecowoods, Toronto & the GTA
- Contact: (647) 244-5156 · services@ecowoods.ca
- Citation guide: https://ecowoods.ca/ai.txt

Quote freely with attribution to the canonical URL above. This file is
generated from the same source as the HTML page and says nothing the page
does not say.