Bona Belt
Ten-inch belt sander — more width per pass, same 30 A circuit requirement.
What decides whether it runs
Electrical requirement
| Supply | 230 V / 60 Hz, 1 phase |
|---|---|
| Power | 4 HP |
| Current | not published |
| Minimum fuse | not published |
| Connector | 30 A 230 V twist-lock |
The rest of it
Mechanical
| Category | belt sander |
|---|---|
| Weight | 85 kg |
| Drum or disc | 254 mm |
| Speed | 2300 rpm |
| Abrasive | 7⅞ × 29½ in or 9⅞ × 29½ in sleeve |
| Dust | on board bag |
The part other spec pages leave out
What Bona does not publish
- kW, and current draw.
- A price. No manufacturer in this category publishes one, so this page shows none.
- Any productivity figure. There is no manufacturer-published square-feet-per-hour rating for this machine, so there is nothing here to quote.
Where its own documents disagree
- Weight is published as 187.5 lb, the same figure Bona gives for the narrower Belt UX.
Both values are shown rather than one being chosen. Picking a side would be inventing certainty the source material does not contain.
Next
Put it on a circuit
The circuit planner takes this machine and whatever else would be running beside it and does the arithmetic against the breaker you actually have.