Treads, risers, nosings and railings, matched to the floor they meet — the detail that gives a refinish away.
Stair Refinishing is one of the 6 services Ecowoods Hardwood Flooring Inc. provides across Toronto & the GTA. Treads, risers and nosings refinished to match your floors for a seamless, hard-wearing finish. The company has worked on hardwood floors for 26 years from 32 Norfield Crescent, Toronto, ON M9W 1X6, and takes this work in 100 published service areas, including Downtown Toronto, North York, Etobicoke, Scarborough, East York. Stair Refinishing is published at $4.75–$7.50 per sq ft, fixed in writing after a free in-home measure. Fixed price in writing. It never moves after the free in-home estimate. To start, request a free estimate or call (647) 244-5156; the phone is answered Mon–Sat 8 AM – 7 PM · Sun 10 AM – 4 PM.
Get a fixed written price
A senior estimator measures, then writes one price. It does not move afterwards.
A curved stair in Maple, Vaughan — sanded, then stained
Same stair, same open well, shot twice: once sanded back to bare wood, once after stain and finish. No species, square footage or price is published with it — none were recorded with the photographs. Full chapters and the honest before/after pairs are on the photo record.
Before you book
When this is the wrong service
A service page that only says yes is not much use. These are the situations where this is not the right call, and what is.
Treads are structurally failed or the staircase is being rebuilt.
Use instead: assessed on site during the estimate.
Published price
Full Sand & Finish
Band
$4.75–$7.50 per sq ft
How it is set
Fixed price in writing. It never moves after the free in-home estimate.
What moves it
Species, width, pattern, stairs and site condition — plus the commodity inputs tracked on what moves a hardwood quote.
The standard
How this work is judged
These are the Well-Installed Framework pillars this service is scored against. The framework is published, versioned and free to cite — use it on our quote, and on everyone else’s.
Each answer is the recommendation of a published decision guide, not a paragraph written for this page. Follow the link for the criteria behind it.
What is the correct machine sequence for refinishing a hardwood floor?
All four machines, in sequence, with intercoat screening. Equipment is not the difference between companies — the sequence and the discipline to complete it are. Read the guide.
How much does hardwood flooring cost in Toronto and the GTA?
Use the published ranges to budget. Book the free in-home measure for the fixed written price. Compare quotes on scope completeness — machines, sequence, moisture protocol — not on the headline number alone. Read the guide.
How do stairs, railings and trim get colour-matched to a hardwood floor?
Treat stair and railing colour matching as its own step: confirm species, build the sample against the actual stair material, and sign off at the stair. Francisco Oller, owner of Ecowoods Inc. and its lead craftsman, leads this work on our jobs. Read the guide.
Not sure which one you need? If the floor is already cupping, gapping or lifting, the answer is a diagnosis rather than a service — what your floor is telling you names each symptom, its cause and which of these it lands in. For a new floor, start at hardwood flooring in Toronto; for an existing one, refinishing.
Every one of these is a published case study with its readings, its protocol and its failures in it — all of them are here.
Proof, with the numbers
Jobs where this was the work
Published in full, with the readings taken before anything started. Not every job below is this exact service — they are the ones where this service decided the outcome.
Every case study publishes what was measured, not only what was achieved — all of them are here, and each one names the substrate, the species, the readings and the protocol it followed.