Lägler FLIP
Edge and corner machine — the only one here that reaches into a corner.
What decides whether it runs
Electrical requirement
| Supply | 110 V / 60 Hz, 1 phase |
|---|---|
| Power | not published |
| Current | not published |
| Minimum fuse | not published |
| Connector | none specified |
| Supply | 230 V / 50 Hz, 1 phase |
|---|---|
| Power | 1.35 kW |
| Current | not published |
| Minimum fuse | 10 A |
| Connector | none specified |
The rest of it
Mechanical
| Category | edger |
|---|---|
| Weight | 9.8 kg |
| Drum or disc | 150 mm |
| Speed | 3100 rpm |
| Abrasive | 150 mm disc; 60 mm corner attachment at 7750 rpm |
| Dust | on board bag |
The part other spec pages leave out
What Lägler does not publish
- kW for the 110 V North American motor — the parts list names the motor but not its rating.
- A price. No manufacturer in this category publishes one, so this page shows none.
- Any productivity figure. There is no manufacturer-published square-feet-per-hour rating for this machine, so there is nothing here to quote.
Next
Put it on a circuit
The circuit planner takes this machine and whatever else would be running beside it and does the arithmetic against the breaker you actually have.